Categories

Hot Products

News

Factors Affecting The Life Of Biomass Pellet Mill
Dec 23, 2018

The biomass pellet machine is based on crop straw or wood chips and is pressed into pellet fuel by biomass pellet machine. Here, we introduce the factors affecting the life of biomass pellet machine:

1. The moisture content of the material is too low, the hardness of the processed product is too strong, and the power consumption of the equipment during processing is large, which increases the production cost of the enterprise and reduces the working life of the biomass pellet machine. If the moisture is too large, it is not easy to be pulverized, and the number of impacts of the hammer is increased. At the same time, heat is generated due to the friction of the material and the hammer, so that the water inside the processed product evaporates, and the evaporated water forms a paste with the pulverized fine powder and blocks the sieve. The hole reduces the discharge of the biomass pellet machine. Generally, the moisture content of the crushed products of the raw materials such as grain and corn stover is controlled to be less than 14%.

2. At the end of the material crushing, mix a little wheat husk with edible oil and put it into the machine. After pressing for 1-2 minutes, stop it, and make the mold hole of the biomass pellet machine full of oil, so that it can be put into production next time. It not only maintains the mold, but also saves man-hours. Loosen the pressure roller adjustment screw after the biomass pellet machine stops, and remove the residual material

3. The permanent magnet cylinder or the iron remover can be installed at the feed port of the biomass pellet machine to avoid affecting the service life of the pressure roller, the mold and the central shaft. The temperature of the pellet fuel during the extrusion process is as high as 50-85 °C, and the pressure roller is subjected to strong driving force during operation, but lacks the necessary and effective dust protection device, so every 2-5 working days, The bearing must be cleaned once and a high temperature grease must be added. The spindle of the biomass pellet machine is cleaned and refueled every other month. The gear box should be cleaned and maintained at intervals of half a year. The screw fastening of the transmission part should be carried out at any time.

Jiangsu Kingwood Industrial Co., Ltd.
Add:No. 568 Hongsheng Road, Liyang, Jiangsu
International Website: www.kingwood-china.com
E-mail: wm003@jskingwood.com
Tel: +86-519-87838999
Fax: +86-519-87828111
Cel: +86-13915862177



  • QR CODE
  • facebook