Categories

Knowledge

The maintenance instructions of the pellet machine
Dec 21, 2017

1. Regular inspection of parts, monthly, check the worm gear, worm, lubrication block bolts, bearings and other activities are flexible and wear and tear, found that defects should be repaired in time, not reluctantly used.

2. The machine should be placed in the dry and clean indoor use, not in the atmosphere containing acids and other corrosive to the body of the gas flow of the place to use.

3. After the use of the machine or stop, you should remove the rotary drum for cleaning and brush the remaining powder, and then installed, for the next use to prepare for work.

4. When the drum in the work occurred before and after the movement, adjust the front of the M10 screws to the appropriate position. If the gear shaft occurs, adjust the rear M10 screws to the appropriate position, adjusting the gap to the bearing does not occur, the hand to the pulley, tightness appropriate, too tight or too loose can cause damage to the possibility of this machine.

5. If the stop time is longer, the machine must wipe clean the whole body, the smooth surface of the parts coated with antirust oil, with a cloth hood good.


  • QR CODE
  • facebook