This series of hammer mill can pulverize all kinds of coarse fibers and large block materials such as branches, bark, plant roots, wood blocks, domestic garbage and chemical waste. It adopts steel plate welding structure. The motor and the hammer mill rotor are installed on the same base. The coupling is directly connected, the rotor is checked by dynamic balance, and the feeding port is at the top of the hammer mill. It can be transported with auger and belt conveying form. The feeding mechanism is matched and the hammers are arranged symmetrically. The machine is simple in structure, sturdy and durable, safe and reliable, easy to install, convenient in operation and maintenance, small in vibration and high in productivity. This series of hammer mill is a coarse pulverizer function, which is suitable for the pulverization of fibrous, high-moisture materials and brittle materials. High output and low energy consumption.This series of hammer mill production license certificate number is the implementation standard code: XK06-013-00599
When the hammer mill is installed correctly, the suction is good, and under normal conditions, the performance indicators are as follows:
Note: The above indicators must meet the following requirements: raw material varieties: moisture content is not more than 17%; bulk density is not less than 0.4 tons / m3. The hammer mill has a mesh hole diameter of φ10*14 mm long hole; the opening ratio is not less than 33% fine grinding. The feed specification is recommended to be below 5 cm and the yield is reduced accordingly. Among them, the smaller power configuration is mainly used for small bulk density and easy to pulverize materials.
Base: It plays the role of connecting and supporting the components of the hammer mill to form a whole. The pulverized powder should be equipped with auger and induced draft fan to discharge.
Rotor: It consists of main shaft, hammer frame, pin shaft, hammer, bearing and other parts. It is the main moving part of the hammer mill. The rotor speed is high, and the dynamic balance test must be carried out without the pin and the hammer after assembly.
The material to be pulverized is uniformly fed from the top feed port through the feeding mechanism matched with the machine, and the material is gradually pulverized under the action of the high-speed rotating hammer striking and the screen plate friction, and passes through the sieve under the action of centrifugal force and air flow. The holes are discharged from the discharge port of the pneumatic conveying type base.